![]() There are two methods to configure this, you can do this via the commandline interface (CLI) or via the graphical user interface (GUI). To prevent this from happening again the USB port dependancy needs to be removed and low and behold Proxmox already has this option built in. The name of the ConBee USB device from Dresden Elektroniks shows up as ‘Future Technology Devices International’ or FTDI.With the port change it was no longer visible in the Home Assistant VM. The ConBee device was configured to use a specific USB Port.The ConBee was assigned to a different USB port after the reboot. The USB port assignment is determined by different factor after a reboot.Like most ‘problems’ multiple things lead to the time-consuming ‘solving’ proces, in this case: It was some time ago since I installed de ConBee device so I had to refresh my memory on how the passthrough was configured in Proxmox. ![]() After the reboot the deCONZ add-on was no longer working.ĭeCONZ complained about not finding the device. I had deCONZ working in Home Assistant and everything was running fine until I rebooted the Proxmox host due to some kernel updates.
0 Comments
Leave a Reply. |